Electrical and Electronic Consulting Engineers
Electrical and Electronic Consulting Engineers
Embedded Files
Case Studies
Case Studies
We have worked with a number of clients on a range of multidisciplinary projects. These included projects where engineers had a very specific problem to overcome to complete design of a products for financial investors. Below are a few examples of our work.
Flow Assurance
Flow Assurance
- Flow assurance is a key requirement of any oil and gas producer
- Cooling of the oil can lead to the build up of waxy deposits resulting in blockages, reduction in output and a loss in profits
- AMCC Consulting is experienced in thermal modelling for ht oil industry
- The simulation enabled us to predict the effectiveness of different configurations in solving the problem
- A system was then designed and built for the customer by AMCC Consulting
A simulation of the effect of heating on a fluid in a pipe.
A single power module using Silicon Carbide MOSFETs.
Silicon Carbide PFC
Silicon Carbide PFC
- A customer required a high voltage (1500 V) DC output stage from a standard UK 3 phase set with a power rating in excess of 300 kW.
- AMCC Consulting was tasked with designing, building and certifying the complete system ready for production.
- In order to minimise the volume, we used state of the art Silicon Carbide modules to perform the boost rectification stage.
- Fibre optic sensors and System on Chip FPGA were used to to control the system.
- We designed a custom controller and simulated it in Matlab's Simulink before implementing it in embedded C and VHDL firmware.
- Safety and performance were key requirements of the project so we worked with Lloyd's Register in order to certify the hardware.
Consumer Electronics
Consumer Electronics
- Consumer electronics are in the general public domain and thus have a wide range of standards which they must meet in order to be fit for sale.
- AMCC Consulting has worked on several electric vehicle projects which required the legal and safety requirements to be identified, prototypes to be designed and built, and provided detailed testing and documentation.
- Our design strategy involves:
- Identify market needs and requirements
- Simulate the a solution
- Design a working prototype for evaluation
- Design a production ready product
- Test the product against the necessary standards and regulations
- Provide detailed support in the manufacture of the product
- Provided full documentation and relevant certification
A prototype circuit board ready for evaluation.
Labs and Offices
Arch 706 Pagden Street
Battersea
London
SW8 4AP
Registered Office
50 Egerton Gardens
Knightsbridge
London
SW3 2BZ
Report abuse